Baby Changing Units - Liberty
Model No. LIBERTY
Specification

Phosphated steel frame coated in white epoxy polyester, vinyl coated woven polyester material, fire retardent to DIN4102 and tested to 52N/mm2 (7500lb/in2).

Frame edges protected with 5omm dia closed cell foam cushions - hygenic white finish throughout, stainless steel hinge pints and wall mounting brackets each with two substantial fixing points to the wall.
Installation

Fit the Baby changer at 900mm above floor and ensure there is adequate space for the parent to COMFORTABLY change baby rfom the side at least one end. Keep the wall above the table clear of obstruction to a height of 1350mm from floor, to allow folding up.

*The 900mm height is most appropriate for general purpose installations. Where particular circumstances apply (eg. frequent use by wheelchair occupants) the working height requirement may be lower.
Fixing
The Liberty Baby Changer arrives with an isolation set and heavy duty fittings to suit most masonary walls and appropriately reinforced stud walls. Where wall build materials are unsuitable ( e.g. aerated, hollow block and most partition walls) special fixing arrangements must be made.